Swivels made for HDD
Pullback swivels are a necessary and important part of every Horizontal Directional Drilling jobs.
The swivel has to be able to stand up to not only the tensile forces caused by the pullback, but also the rotational forces and the side loads caused by rocks or certain other conditions.
For this reason the bearings in our swivels are suitable for absorbing both thrust and radial loads. Our swivels have specially designed seals to prevent ingress of dirt to the bearings which would cause premature failures. The seals can withstand mud, grime and anything else found underground and are designed to be easily serviceable.
NEW Dub Swivel
Dub Swivel | |
Part # | |
5-ton Dub Swivel |
SWD5 |
9-ton Dub Swivel |
SWD9 |
20-ton Dub Swivel |
SWD20 |
35-ton Dub Swivel |
SWD35 |
Choose the right HDD Swivel for your Horizontal Directional Drill
Choosing the right pulling swivel should be determined by the capacity of the machine, not just the load being pulled. When selecting a pulling swivel, one should select a unit with equal or greater capacity than the machine it will be used on. Don’t hesitate to contact us to help you choosing the right pullback swivel for your next Horizontal Directional Drilling job.
5-ton Swivel, 9-ton Swivel and 16-ton Swivel below. See table for the other size.
For your reamer subs, click here to see our range
With a simple Pulling Eye Adaptor, turn your swivel into a dub swivel. See the table beside for available sizes.
Adaptor suitable for Vermeer® and Ditch Witch® back reamers to suit our 5T, 9T & 16T Swivels.
Note : These adaptors are ideal for connecting small packages straight to the Starter Rod when back reaming is not required.
Swivels | |
Part # | |
5-ton Swivel, 70mm dia, 296mm total length |
SW5 |
9-ton Swivel, 76mm dia, 330mm total length |
SW9 |
16-ton Swivel, 110mm dia, 432mm total length |
SW16 |
20-ton Dub Swivel |
SWD20 |
35-ton Dub Swivel |
SWD35 |
Pulling Eye adaptor for 5 T swivel |
SP5 |
Pulling Eye Adaptor for 9 T Swivel |
SP9 |
Pulling Eye Adaptor for 16 T Swivel |
SP16 |
Adaptor suitable for Vermeer® D7x11 back reamers |
SSV711 |
Adaptor suitable for Vermeer® D16x20, D20x22 and D24x40 back reamers |
SSV2440 |
Adaptor suitable for Ditch Witch® JT1720 and JT2020 back reamers |
SSD2020 |
Copyright © 2024 No Dig Equipment. All Rights Reserved.